Fil-Tech, Inc.
Boston, MA
Boston, MA 02114
617-227-1133 Tel
617-742-0686 Fax
www.filtech.com
MATERIAL SAFETY DATA SHEET
FT704
Manufacturer: Fil-Tech, Inc.
Address: 6 Pinckney St.
Boston, MA 02114
Telephone: 617-227-1133
Fax: 617-742-0686
Emergency Phone Number: 617-227-1133
Product Indentification
Chemical Name of Primary Componet: Tetramethyltetraphyenyltrisiloxane
CAS Number: 3982-82-9
Ingredients/Summary of Hazards
Ingredients: Tetrametyltetraphenyltrisiloxane
CAS Number: 3982-82-9
OSHA Hazardous (H)/ Non-Hazardous (NH): NH
Percent: 100
SARA Title III Hazard Classification: Non-Hazardous
Warning Statements: Based on currently available
data, this product does not meet the
OSHA definition of a hazardous substance. However, good industrial hygiene practices
should be used in handling it.
Physical Data
Melting Point F: Not applicable
Boiling Point F: Not applicable
Vapor Pressure (mmHg at 20 C): 1 x 10-8
Solubility in Water: Insoluble
Specific Gravity: 1.07 @ 25 C
Evaporation Rate (butyl acetate = 1): Not applicable
% Volatile by Volume: Not applicable
Appearance/Odor: Clear to pale yellow viscous liquid/odorless
Viscosity: 40 mm2/s @ 25 C
Fire and Explosion Hazard Data
Flash Point F/Method: 478/AFNOR T 60103
Flammable Limits: LFL Not applicable UFL Not
applicable
Extinguishing Media: Dry Chemical, Foam, CO2
Special Fire Fighting Procedures: Wear a NIOSH/MSHA
approved self-contained breathing
apparatus and full protective clothing. Cool containers exposed to fire with water.
Unusual Fire and Explosion Hazards: Auto-ignition
temperature: 450 C (812 F)
Reactivity Data
Stability: Stable
Conditions to avoid: Avoid heat and open flame
Incompatibility (materials to avoid): Strong acids,
Strong oxidizing materials, strong bases.
Hazardous Decomposition Products or Byproducts: At
temperatures above 300 C (572 F),
Benzene may be released. On combustion, silica and oxides of carbon are emitted.
Hazardous Polymerization: Will not occur
Conditions to avoid: Not applicable
Health Hazard Data/First Aid Procedures
Exposure Limits in Air: No exposure limits established
for product.
Effects of Single Overexposure:
Swallowing: Animal tests
for similar silicone fluids suggest very, low acute oral toxicity. (1)
Skin Absorption: Animal tests
for similar silicone fluids suggest very, low acute oral toxicity.
(1)
Inhalation: This is a viscous
fluid that does not easily form a mist or vapor and, therefore,
inhalation hazards are minimal.
Skin Contact: Similar silicone
fluids are non-irritating to intact and abraded rabbit skin. (1)
Eye Contact: Similar silicone
fluids are non-irritating to rabbit eyes. (1) A slight transient
irritation is possible.
Effects of Repeated Overexposure: No data found.
Carcinogenicity: This product does not contain any
ingredient designated by IARC, NTP,
AOGIH or OSHA as a probable human carcinogen.
Significant Laboratory Data With Possible Relevance to
Man: No data found.
Medical Conditions Possibly Aggravated by Overexposure: No data found.
Health Hazard Data/First Aid Procedures
First Aid Procedures:
Eyes: In case of contact, wipe off excess with a
clean gauze pad or cotton and then flush eyes
with plenty of water for at least 15 minutes using and eyewash fountain. Lift upper and lower
lids and rinse well under them. Get medical attention if irritation develops or persists.
Skin: In case of contact, wipe off excess with a
clean clothe and them wash with soap and
plenty of water. Get medical attention if irritation develops or persists.
Inhalation: Although it would be difficult to inhale
this product, seek medical attention if is
should occur.
Ingestion: If swallowed and victim is fully conscious,
induce vomiting immediately by giving
two glasses of water and sticking finger down throat. Get Immediate Medical Attention.
Note to Physician: All treatments should be based
on observed signs and symptoms of
distress in the patient. Considerations should be given to the possibility that overexposure to
materials other than this product may have occurred.
Treat symptomatically. No specific information found.
Precautions for Safe Handling and Use
Steps to be Taken If Material is Released or Spilled: Wear
appropriate protective gear.
Absorb onto vermiculite. Sweep up into appropriate container. Wash spill area after material
pickup is complete with an appropriate solvent like paint thinner.
Waste Disposal Method: Dispose of in accordance with
Local, State, and Federal
regulations.
Handling and Storage: Store at room temperature in
tightly closed containers. Avoid direct or
prolonged contact with skin and eyes. Wash hands thoroughly after handling. Do not rub
eyes with solid hands. Do not eat, drink or smoke in work area.
Other Precautions: None found.
Control Measures and Worker Protection Information
Respiratory Protection: No special respiratory required
for product as sold.
Ventilation: Provide adequate ventilation.
Protective Clothing: Work clothing, gloves.
Eye Protection: Safety glasses with side shields.
Other Protective Equipment: Maintain a sink, safety
shower and eyewash fountain in the work
area.
Regulatory Status
TSCA Inventory Status: Product is TSCA certified.
Transportation Status: Not regulated.
Reportable Quantity (RQ) under U.S. EPA CERCLA: Not
applicable
Specifically Listed under SARA Title III: Not listed
Date/International Right-to-Know Regulations:
California: Not listed
Connecticut: Not listed
Florida: Not listed
Illinois: Not listed
Louisiana: Not listed
Massachusetts: Not listed
New Jersey: Not listed
New York: Not listed
Pennsylvania: Not listed
Rhode Island: Not listed
Canada: Not listed
Date Prepared: 2/12/90
Supercedes: 8/22/86
MDSD Number: 022119-21.FER
|
